Instructions for installing V series machine software.

Please save the software attachment below to your hard drive, and then to either a blank 3.5" high density floppy disk or CompactFlash card. Label the disk:

VS/VY System Disk
Version [####]

To load this software from floppy (multi-head machines only):

Turn the power OFF at the Automat.
Insert the floppy disk with the new system software on it.
Press and hold the Read key, while powering ON (on the Automat) until you see the "System Version" Screen.
Press the Read key to start the update process. Update takes a few minutes.
After the update completes, seek origin as you normally would upon power-on.

To load this software from CF card:

Create a new folder on the CF card named SYSTEM.
Save the software download to the SYSTEM folder you just created.
Turn the power OFF at the Automat.
Insert the CF card with the new system software on it.
Press and hold the Read key, while powering ON (on the Automat) until you see the "System Version" Screen.
Press and hold the Memory key to read the system files.
Select the correct system file to load by using the Jog keys, then press and hold the Execute key for 5 seconds to start the update process.
After the update completes, seek origin as you normally would upon power-on.

VS/VY Software

This software is for Barudan "V" series machines with more than one sewing head. Specific model numbers include:

BEVY-Z1502C, BEVY-Z1504C, BEVY-Z1506C, BEVY-Z1508C
BEVS-Z1512C, BEVS-Z1515C

This file can be used for updating with CF cards, or with a floppy disk:

Vsb.sys Current Release V1.50 R00
(dated 1/6/2008)

BEVT Software

This software should be copied to a CF card for updating your Barudan single head Elite models:

BEVT-Z901CA Elite XL
BEVT-Z1501CB Elite Pro
BEVT-Z1501C Single Head

Please save the software attachment below to your hard drive, and then to a CompactFlash card.

Create a new folder on the CF card named SYSTEM.
Save the software download to the SYSTEM folder you just created.
Turn the power OFF at the Automat.
Insert the CF card with the new system software on it.
Press and hold the Start button, while powering ON (on the Automat.
Press and hold the Start button again, to read the system files from the CF card
The "System Version" Screen will appear
Select the correct system file to load by using the Jog keys, then press and hold the Execute key for 5 seconds to start the update process.
After the update completes, seek origin as you normally would upon power-on.

Software should update automatically and may take a few minutes to complete. Once it stops and the seek origin screen appears, the machine is ready to go.

VTB150R0.sys Current release (dated 1/6/08)

This release corrects several minor bugs and adds several enhancements- the software can now turn the MK510080 laser on and off from the manual screen.

V Series Software Downloads